PCRAC - PROCOVER (steel) - JOINT-COVER PROFILES
STAINLESS STEEL AISI 304/1.4301 POLISHED AND SATIN FINISH
"PROCOVER" is a joint-cover profile in stainless steel (polished or satin finish) or in anodised aluminium. It is applied at the end of laying two adjoining floors with the same height, having left a 6 - 24 mm gap between the two floors set in a thin bed of adhesive. It protects the outside edges of the
floor/covering. It is easy to lay and attractive. The design of the profile with lower vertical arrowhead part allows excellent anchorage with the silicone/adhesive.
POLISHED STAINLESS STEEL AISI 304/1,4301 with protection film - bar length 2,70 LM (PCRAC 1499 bar length 0,90 LM)
| Article |
L x H mm |
| PCRAC 149 |
14 x 9 |
|
Pack. 108 LM |
| Article |
L x H mm |
| PCRAC 1499 |
14 x 9 |
|
(bar length 0,90 LM) Pack. 20 Pcs - ECOBLISTER |
| Article |
L x H mm |
| PCRAC 269 |
26 x 9 |
|
Pack. 81 LM |
SATINED STAINLESS STEEL AISI 304/1,4301 - bar length 2,70 LM (PCRACS 1499 bar length 0,90 LM)
| Article |
L x H mm |
| PCRACS 149 |
14 x 9 |
|
Pack. 108 LM |
| Article |
L x H mm |
| PCRACS 1499 |
14 x 9 |
|
(bar length 0,90 LM) Pack. 20 Pcs - ECOBLISTER |
| Article |
L x H mm |
| PCRACS 269 |
26 x 9 |
|
Pack. 81 LM |
LAYING INSTRUCTIONS
1: Choose the "PROCOVER’’ with the width suitable for the gap between the two floors to be joined, taking into consideration 2/3 mm side lap. 2: Fill the gap with single-pack silicone or with the adhesive used for laying the floor. 3: Bury the profile into the adhesive, making sure that both side laps of the profile rest on the coverings to be joined.
